Setting up an Epson TM20 Receipt Printer

Instructions for installing Epson TM20 USB receipt printer on Windows.

Note: This guide is only for an EPSON TM20 connected via USB. For serial connection, there is no driver download necessary it should always automatically be detected and set to COM1.

Download the appropriate Printer Driver from the Epson website here.

Once the driver has been downloaded run the file.

Click Next and agree to the terms and conditions. You will then be prompted to register the printer. To do this it is important to power the printer ON first, then click Next to proceed.

mceclip0.png

Select <New Printer> so that it becomes highlighted. Then under "Port Type" select USB and "Port" to Auto Setup. From here tick "Set as default printer" in the tickbox and click Save Settings. Now the printer has been initially set up so press Next to complete the process.

mceclip1.png

Now that the printer has been installed we need to set up a Virtual COM port to be detected by Phorest. Download the Epson Virtual COM installer from here. Select TMVirualPortDriver830b.zip and then download and extract to the desktop.

mceclip2.png

Run the installer and once the installation completes you should be prompted with the screen below asking to assign a virtual COM port. Select the desired port  (In this example COM8) and click Assign Port.

mceclip3.png

You will then be prompted with the below screen asking to select the desired printer to assign to the virtual COM port. Select the TM20 as shown below and click OK.

mceclip4.png

Once done you should see the printer assigned to the desired port as listed below.

mceclip5.png

The final step is to configure this in Phorest. Go to Manager > Settings > Point of Sale > Device and under "Receipt Printer Configuration" select Direct. Under "Model" select Star TSP100 (Do NOT select any Epson model).

Now under "Port" select the COM you have previously set up. In this case COM8. To finish the process simply click Save in the bottom right-hand corner of Phorest. You may wish to reprint a receipt from Phorest to test this is configured correctly. It is also important to test the cash drawer to confirm it opens when prompted.

mceclip6.png

This guide is only for an EPSON TM20 connected via USB. For serial connection, there is no driver download necessary it should always automatically be detected and set to COM1.

Was this article helpful?
2 out of 8 found this helpful