How to connect your Ethernet (Wired) Phorest Pay Device

The following guide will show you how to set up your wired Phorest Pay device, and is applicable to devices such as the Ingenico IPP320, Ingenico Lane 3000, Ingenico Lane 5000, and Ingenico Lane 7000.

Note: Due to regulatory constraints this feature is only available in North America.

 First Steps!

The first step you will need to take is to connect your Phorest Pay device to your modem/router via an ethernet cable, then power on your Phorest Pay device and follow the guide below.


Was this article helpful?
0 out of 0 found this helpful